The information in this article applies to:
- GFI FaxMaker 2011 for Exchange/SMTP
- GFI FaxMaker for Exchange 10
- GFI FAXmaker for Exchange 7
- GFI FAXmaker for Exchange 9
- GFI FAXmaker for Exchange/SMTP 12
- GFI FaxMaker for Exchange/SMTP 14
- GFI FAXmaker for Networks 11
- GFI FAXmaker for Networks/SMTP 10
- GFI FAXmaker for Networks/SMTP 8
Article ID: KBID001220
Query keywords:
analog, AVM, Bintec, Brooktrout, device, Dialogic, Fax Over IP, FoIP, isdn, LANCOM, Mainpine, modem, modems, PrimuX, XCAPI
GFI FAXmaker supports the following devices:
- AVM cards
- These support ISDN BRI
- A full list of the supported AVM cards can be found at KBID002459
- Brooktrout cards
- Dialogic (Eicon) cards
- These support Analog, ISDN BRI, ISDN PRI -E1/T1, and Fax over IP
- A full list of the supported Dialogic cards can be found at KBID002460
- Mainpine cards
- These support Analog
- A full list of the supported Mainpine cards can be found at KBID002653
- PrimuX cards
- These support ISDN BRI, ISDN PRI
- A full list of the supported PrimuX devices can be found at KBID003093
- Modems
- Only Analog modems are supported
- A fax card is preferred to a normal modem
- A full list of the supported modems can be found at KBID002461
- XCAPI
- Software-only Fax over IP (FoIP) solution.
- Further information on how to configure GFI FAXmaker to use XCAPI can be found at: KBID003492
- LANCOM
- FAX Gateway Devices
- Further information on how to configure GFI FAXmaker to use a LANCOM device can be found at: KBID003894
- A full list of the supported LANCOM devices can be found at: KBID003891
- Bintec
- FAX Gateway Devices
- Further information on how to configure GFI FAXMaker to use a Bintec device can be found at: KBID003692
- A full list of the supported Bintec devices can be found at: KBID003892
Note:
- GFI FAXmaker was only tested with each card separately. If you want to use multiple cards/devices, you will need to check with the manufacturer of the respective cards to ensure that there are no incompatibilities between the different cards you are going to use.